Honeywell Discharge Air Temperature Sensor for use with the W8735 Telephone Access Module

A duct-mounted temperature probe used to provide capacity control of heating and cooling equipment. Used with Honeywell Network Zoning System and single unit zone applications.

Mounted in the supply air duct, the DATS senses delivered air temperature and cuts off the heating and cooling when delivered air temperature goes above or below normal operating limits.

When used with W8735B telephone Access module, will alert and dial out on HVAC equipment failure.

Requires three wires. Uses standard 18-22 gauge thermostat wire.

Application: Sensor

Description: Communicating Discharge Air Temperature Sensor.

Heat Pump Compatible: Yes

Humidity Ratings: 90% at 95 F non-condensing.

LED Indicators: Yes

Mounting: Duct Mounted.

Network Zoning: Yes

Power Method: Hardwired (receives power from equipment low voltage transformer)

Voltage: 24 Vac

Ambient Temperature: -40 F to +170 F; -40 C to +70 C

Frequency: 50 Hz; 60 Hz

Dimensions: 3 7/8 in. high, 4 1/8 in. wide, 4 in. deep; 77 mm high, 105 mm wide, 102 mm deep

Replaces Part Numbers: CARC7835A1009