My Account | Cart/Checkout | Help

TOTALINE Star Series CG1000 Electronic Air Cleaners - Maintenance, Care and Replacement Instructions

Typically, cleaning should be performed every month. Once cleaning has been performed, hold up the electronic air cleaner to a strong light. If the outline of the center screen can be seen, the fiberglass filter pads do not need to be replaced. If the outline cannot be seen, replace the fiberglass pads. Typically, the fiberglass pads will need to be replaced every 3 to 6 months.

Cleaning

1. Unplug the power cord from the electronic air cleaner and remove the air cleaner from the filter rack. See Fig. 3.
2. Vacuum the Outside mesh screens of the electronic air cleaner if lint is present. A soft cloth and water mixed with detergent can be used to clean the outside of the device. Do not use alcohol, organic solvents or other chemical agents for cleaning. To avoid damage to electrical components, do not wash the electronic air cleaner with excessive water.
3. Plug the power cord back in and re-install the electronic air cleaner into the filter rack.

1. Unplug the power cord from file electronic air cleaner and remove the air cleaner from the filter rack. See Fig. 3.
2. Open the electronic air cleaner by lifting the latches on the side of the frame.
3. Remove the two dirty pads from inside the electronic air cleaner.
4. Place the two new pads (purchased separately) on either side of the center screen. See Fig. 5. Be sure the pads fit squarely into the outside retainer screens.
5. Close the electronic air cleaner and make sure the latches are secured.
6. Place the electronic air cleaner back into the filter rack and plug in the power cord.

TROUBLESHOOTING

If the air cleaner does not seem to be functioning, check the following:
1. Verify that the power supply light is on. If light is off, check power supply and wiring connections. If power supply light is on, perform maintenance procedure and replace fiberglass filters.

Top of Page ^